Fax Receive Settings
Menu item Description
Enable Fax Receive
On
Off
Allows fax jobs to be received by the printer
Note: On is the factory default setting.
Fax Job Waiting
None
Toner
Toner and Supplies
Allows a fax to be held until toner or supplies are replaced
Notes:
• This menu item appears only if a hard disk is supported and installed.
• None is the factory default setting.
Rings to Answer
1–25
Specifies the number of rings before answering an incoming fax job
Note: 3 is the factory default setting.
Auto Reduction
On
Off
Scales an incoming fax job so it fits the size of the paper loaded in the designated fax
source
Note: On is the factory default setting.
Paper Source
Auto
Tray <x>
Multi-Purpose Feeder
Specifies the paper source selected to supply paper for the printer to print an incoming
fax
Note: Auto is the factory default setting.
Separator Sheets
None
After job
Before job
Places a sheet of paper before or after a received fax.
Note: None is the factory default setting.
Separator Sheet Source
Tray <x>
Manual feeder
Specifies a paper source.
Note: Tray <x> is the factory default setting.
Sides (Duplex)
On
Off
Enables duplex printing (two-sided printing) for incoming fax jobs
Note: Off is the factory default setting.
Fax Footer
On
Off
Prints the transmission information at the bottom of each page from a received fax
Note: On is the factory default setting.
Max Speed
2400
4800
9600
14400
33600
Specifies the maximum speed in baud at which faxes are received
Note: 33600 is the factory default setting.
Fax Forwarding
Forward
Print
Print and Forward
Enables forwarding of received faxes to another recipient
Understanding printer menus
197
To Next Page
Loading...
