EasyManuals Logo

Ricoh Pro C5200s User Manual

Ricoh Pro C5200s
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #165 background imageLoading...
Page #165 background image
8. Adding Paper and Toner
This chapter describes how to load paper into the paper tray and recommended paper sizes and types.
Loading Paper
Precautions for Loading Paper
When loading paper, take care not to trap or injure your fingers.
Do not stack paper over the limit mark.
To prevent multiple sheets from being fed at once, fan the paper before loading it.
If you load paper when only a few sheets of paper remain in the tray, multiple sheet feeding may
occur. Remove any remaining paper, stack them with the new sheets of paper, and then fan the
entire stack before loading it into the tray.
Straighten curled or warped paper before loading.
When you load paper into the paper tray for the first time or when you change the size or type of
paper in the paper tray, be sure to specify the appropriate paper settings in Tray Paper Settings.
For details, see "Changing Tray Paper Settings", Paper Settings.
For details about the paper sizes and types that can be used, see page 189 "Recommended
Paper Sizes and Types".
You might at times hear a rustling noise from paper moving through the machine. This noise does
not indicate a malfunction.
Fanning the paper
If you load coated paper, label paper, transparencies, or thick paper of 150.1–360.0 g/m
2
(55.1 lb. Cover–198.0 lb. Index) in the paper trays, bypass tray, or wide LCT, it is important that
you fan the sheets thoroughly. Misfeeds may occur if paper is not fanned thoroughly. If the machine
feeds several sheets of paper together or it does not feed paper, fan paper and load it again.
163

Table of Contents

Other manuals for Ricoh Pro C5200s

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh Pro C5200s and is the answer not in the manual?

Ricoh Pro C5200s Specifications

General IconGeneral
Print TechnologyLaser
Max Paper Size330.2 x 487.7 mm
Monthly Duty Cycle300, 000 pages
Print Speed65 ppm
Resolution1200 x 4800 dpi
Paper Input Capacity8, 250 sheets
Paper Weight52 to 360 gsm
Duplex PrintingStandard
Network ConnectivityEthernet 10Base-T/100Base-TX/1000Base-T
Supported Media SizesA3, A4, A5, B4, B5
Supported Media TypesPlain, Recycled, Coated, Envelope
Warm-up TimeLess than 5 minutes

Related product manuals