Ricoh Pro C5200s - Registering an E-Mail Destination

The settings explained in "Entering the E-mail Subject", "Entering the E-mail Message", and
"Security Settings to E-mails", Scan, can also be specified.
6. Specify the destination.
You can specify multiple destinations. For details, see "Specifying the Destination or Recipient",
Scan.
7. Press [Sender Name], select the e-mail sender, and then press [OK].
For details, see "Specifying the E-mail Sender", Scan.
8. To use Message Disposition Notification, press [Recept. Notice].
If you press [Recept. Notice], the selected e-mail sender will receive e-mail notification when the e-
mail recipient has opened the e-mail.
9. Press the [Start] key.
Registering an E-mail Destination
1. Display the [Address Book Management] screen.
• When using the standard operation panel
1. Press the [Home] key on the lower left of the control panel.
1. Press the [Address Book Management] icon on the [Home] screen.
• When using the Smart Operation Panel
1. Press [Home] ( ) at the bottom of the screen in the center.
1. Press the [Address Book Management] icon on the [Home] screen.
2. Check that [Program / Change] is selected.
3. Press [New Program].
4. Press [Change] under "Name".
The name entry display appears.
5. Enter the name, and then press [OK].
6. Press [ Next].
Basic Procedure for Sending Scan Files by E-mail
145