3. Release the locks on both of the paper guides.
4. Insert the paper print side up as far as it will go into the machine.
5. Put your fingers on the dimples on the front and rear paper guides and align the paper
guides to the paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might
occur.
6. While holding the paper guides with your hands, lock both of the paper guides again.
Make sure that the total of the gaps between the paper and the front and rear paper guides does
not exceed 0.75 mm (0.03 inches).
Loading Paper
173
To Next Page
Loading...
