3. Make sure [Immed. TX] is not highlighted.
4. Place the original into the ADF.
See "Setting an Original to Send by Fax on the Scanner", User Guide.
5. Make the scan settings such as scan size and resolution.
See "Specifying Scan Settings for Originals for Fax Transmission", User Guide.
6. Configure the transmission settings such as [TX Mode] as necessary.
7. Specify a destination.
You can enter the destination's number or address directly or select from the Address Book by
pressing the destination key.
If you make a mistake, press [Clear], and then enter again.
See "Specifying a Fax Destination", User Guide.
3. Fax
114
To Next Page
Loading...
