Ricoh Pro C5300S - When Ejecting Banner Sheets to Finisher Sr5110;Booklet Finisher SR5120; When Ejecting a Large Number of Booklets to the Booklet Tray of Booklet Finisher SR5120

3. Attach the banner support tray by inserting the protrusions on its underside into the holes
on the finisher shift tray 1 or 2.
D0CPIC1774
4. Press the [Suspend/Resume] key to resume printing.
• Depending on the brand of the paper being used, the paper may be ejected normally even when
the banner support tray is not attached.
• When the banner support tray is attached, output sheets may not be stacked neatly.
• If you set [Finisher Output Tray Settings] to [Auto Change] and [Do not Stack Jobs], and change
where to deliver the paper when the banner support tray is attached, multiple jobs may be
delivered to and stacked on the same tray.
When Ejecting Banner Sheets to Finisher SR5110/Booklet Finisher SR5120
When ejecting banner sheets to Booklet Finisher SR5120, attach an SR5000 series output tray for
banner sheet to Finisher Shift Tray 1 or 2. For details about attaching an SR5000 series output tray for
banner sheet, contact your service representative.
Also set the banner support tray. For details about how to attach the banner support tray, see page 45
"When Ejecting Carbonless Paper Weighing 63 g/m
2
or Less to Finisher SR5110/Booklet Finisher
SR5120".
When Ejecting a Large Number of Booklets to the Booklet Tray of Booklet
Finisher SR5120
When ejecting a large number of booklets to Booklet Finisher SR5120, fold the booklet finisher tray
under as shown.
1. Getting Started
46