Ricoh Pro C5300S - When Using the Staple Function of Finisher Sr5110;Booklet Finisher SR5120 on Thin Coated Paper Weighing 80 G;M2 or Less

D0CPIC1775
• The finisher booklet tray can be folded in two angles.
• The approximate number of copies that can be ejected when the finisher booklet tray is not folded
is as follows:
• When binding 2–5 sheets: 45 copies
• When binding 6–10 sheets: 23 copies
• When binding 11–15 sheets: 15 copies
• When binding 16–20 sheets: 10 copies
• When binding 21–30 sheets: 5 copies
When Using the Staple Function of Finisher SR5110/Booklet Finisher SR5120
on Thin Coated Paper Weighing 80 g/m2 or Less
When using the staple function of Booklet Finisher SR5120 on thin coated paper weighing 80 g/m
2
or
less, attach the two paper strengthening ribs to the staple tray.
The paper strengthening ribs are not supplied. To use the paper strengthening ribs, contact the service
representative.
• When using the staple function on paper other than thin coated paper weighing 80 g/m
2
or less,
remove the paper strengthening ribs, and then set [0840 Staple Tray: Rib Installed Mode to
Strengthen Paper] in [Adjustment Settings for Operators] to [Off].
• Attach the paper strengthening ribs also if paper jam occurs inside the staple tray.
1. Open the finisher front cover.
2. Holding the Rb12 handle, pull out the staple unit.
Special Notes When Using External Options
47