Scan settings on the partial scan setting screen
1. Original Size (X1 and Y1)
Specify the original's entire size.
Enter the actual values in [X1] and [Y1] while referring to "How to measure sizes", and then press [ ].
2. Start Position (X2 and Y2)
Specify the scanning start position.
Enter the actual values in [X2] and [Y2] while referring to "How to measure sizes", and then press [ ].
3. Scan Area (X3 and Y3)
Specify sizes of the area you want to scan.
Enter the actual values in [X3] and [Y3] while referring to "How to measure sizes", and then press [ ].
• See "Setting of Original Feed Type", User Guide.
Edit
Make editing settings.
[Erase Center / Border]
Press to erase the image from a specified width around the document and in the center of the
document when the document is scanned.
If you select [Same Width], you can specify a uniform width for deletion all around the original
(top, bottom, left, and right sides) or in the center. If you select [Different Width], you can specify a
different width for deletion for each side.
[Reduce / Enlarge]
When scanning a bundle of mixed size originals, you can unify the size of the scanned data by
using [Specify Size].
Procedure for Specifying Scan Settings
171
To Next Page
Loading...
