Ricoh Pro C5300S - Page 172

• For X and Y, you can specify 10 mm (0.4 inches) or larger.
• See "Setting of Original Feed Type", User Guide.
Scanning part of a custom size original
If you want to scan only a part of a custom size original, select [Partial Scan] as the scan size.
To display the partial scan setting screen, on the initial scanner screen, press [Scan Settings] [Scan
Size] [Partial Scan].
To scan part of an original, measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan
Area (X3 and Y3) on the front side of the original, and then enter those values on the partial scan setting
screen.
Measuring methods differ depending on where the original is placed and the orientation it is placed in.
For details about how to measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area
(X3 and Y3) correctly, see "How to measure sizes".
How to measure sizes
Orientation and placement of original Measuring method for scanning the "R" section
In the or orientation on the
exposure glass or in the ADF.
CKW042
In the or orientation in the ADF.
CKW043
In the or orientation on the
exposure glass.
CKW044
5. Scan
170