Loading Paper into the Twin Interposer
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
Load paper in the Interposer Upper Tray and Interposer Lower Tray in the same way. This procedure for
the Interposer Upper Tray is described.
1. While pressing the release lever, align the side fences with the paper size to be loaded.
2. Load paper orderly.
Do not stack paper over the limit mark.
The interposer tray automatically starts the operation shortly after loading paper. Adjust the side
fences and end fence before that.
Align the side fences gently against the paper you loaded, if necessary.
While pressing the release lever, align the end fence to the loaded paper.
Loading Paper into the Paper Tray
237
To Next Page
Loading...
