Ricoh Pro C5300S - When the Hole Punch Receptacle Is Full

When the Hole Punch Receptacle Is Full
Empty the hole punch receptacle by following the procedure described in the animated illustration
displayed on the control panel.
1. Press [Check Status] [Maintnc./Inquiry/Mach. Info].
DZC730
2. Press [Guid. : Empty Rec.] under "Punch Receptacle Full".
DZC731
3. Follow the procedure described in the animated illustration, and empty the hole punch
receptacle.
D0CPPC1563
• If the message remains even after you empty the receptacle, remove the receptacle and set it
again.
11. Troubleshooting
466