3. Set the side fences to the size of the paper to be loaded, and then load paper into the
tray.
4. Attach the small tab end fence, and then align the end fence gently against the paper you
loaded while pressing the release button of the end fence.
5. Carefully push the paper tray fully in until it clicks.
6. Specify the paper settings.
page 289 "Overview of Paper Settings"
• Replace the small tab end fence after use.
Loading Paper into the Interposer
• Do not place anything on top of or leave documents on the sensor. This may lead to the paper size
not being correctly scanned or paper jams.
• When using the Z-fold function, the paper in the interposer must be of the same size as the prints
after they have been folded. If the paper in the interposer is larger than the Z-folded sheets, a
misfeed might occur.
• Do not use paper that has already been printed onto by this machine.
1. Load paper orderly.
Do not stack paper over the limit mark.
Loading Paper into the Paper Tray
235
To Next Page
Loading...
