Ricoh Pro C5300S - Sending the Fax Transmission Result; Printing the Fax Transmission Result and Sending It by E-Mail

Memory Transmission
You can confirm the result with a Communication Result Report.
This report is printed each time a Memory Transmission is completed if turned on with User
Parameter (switch 03, bit 0) in the Fax Settings menu.
If the machine is set up not to print this report and the fax document could not be successfully
transmitted, a Communication Failure Report is printed.
For details about the contents printed in the reports, see page 123 "Communication Result Report
(Memory Transmission)" or page 123 "Communication Failure Report".
Immediate Transmission
You can confirm the result with an Immediate TX Result Report.
Select to print this report in User Parameter (switch 03, bit 5) in the Fax Settings menu. A report is
printed after every Immediate Transmission is completed.
For details about the contents printed in the report, see page 123 "Immediate TX Result Report
(Immediate Transmission)".
For details about Parameter Setting, see the section below:
See "List of Parameter Settings", User Guide.
Sending the Fax Transmission Result
Use the Email TX Results function to send reports by e-mail to a computer, and then confirm them on the
computer.
The available reports are:
• Communication Result Report.
• Immediate TX Result Report.
• Polling with SEP RX Result.
For details about Email TX Results, see the section below:
See "Checking Transmission Results by E-Mail", User Guide.
You must first register the e-mail addresses of the destinations the report is to be sent to on the Address
Book.
See "Registering E-mail Addresses in the Address Book", User Guide.
Printing the Fax Transmission Result and Sending It by E-Mail
You can confirm transmission results using both the Email TX Results function, which sends the results by
e-mail, and the Communication Result Report printed by the machine.
3. Fax
122