7. While holding the paper guides with your hands, lock both of the paper guides again.
Make sure that the total of the gaps between the paper and the front and rear paper guides does
not exceed 0.75 mm (0.03 inches).
8. Specify the paper settings.
page 289 "Overview of Paper Settings"
Closing the Multi Bypass Banner Sheet Tray
1. Lightly pull up the extender, and then fold it into the machine.
2. Raise the multi bypass banner sheet tray towards the machine until it clicks, and then
tilt it to the opposite side.
8. Paper Specifications and Adding Paper
212
To Next Page
Loading...
