*3
When the banner sheet tray is installed, paper sizes are not detected automatically.
*4
When the banner sheet tray is installed, you cannot select paper sizes.
*5
You can print on paper whose size is between 210.0-330.2 mm (8.27-13.00 inches) vertically and
420.0-700.0 mm (16.54-27.55 inches) horizontally if the banner sheet tray is installed.
*6
When the banner sheet tray is attached, up to 800 sheets of paper whose horizontal length is 420.0 -700.0
mm (16.54 -27.55 inches) can be loaded and fed.
*7
When the banner sheet tray is installed, you cannot select paper types.
*8
Do not stack paper over the limit mark. The maximum number of sheets you can set at once depends on the
paper's thickness and condition.
*9
The tab fence is required.
*10
Open the flaps, and load the envelopes with their flaps pointed toward the right side of the paper tray.
*11
It is necessary to specify the sizes of the envelopes including their flap sizes using [Custom Size] in [Tray
Paper Settings].
*12
The envelope sizes on the table do not include their flaps.
*13
Flatten curls so that they fit within the following guidelines.
Black color paper: Curl height 5 mm (0.2 inches) or below, R over 100 mm (3.94 inches).
Other papers: Curl height 10 mm (0. 4 inches) or below, R over 100 mm (3.94 inches).
*14
Flatten the curl on the envelope, then set the difference of the stack height of the bottom of the envelope and
the stack height of the flap portion to be 10 mm (0.4 inches) or below.
*15
The optional carbonless paper unit is required.
*16
Paper cannot be fed from the banner sheet tray.
*17
Attach the small tab end fence when loading carbonless paper of paper weight 2 or less.
*18
When loading the following paper, attach the small tab end fence:
B5 JIS (width: 182 mm; length: 257 mm)–SRA4 (width: 225 mm; length: 320 mm) of Paper Weight 8
*19
Avoid use in high temperature and humidity.
Recommended Paper Sizes and Types
263
To Next Page
Loading...
