Icon Condition Solution and reference
Paper is jammed. See the animated illustration displayed on the
control panel, and remove the jammed
paper.
page 451 "When Paper or an Original Is
Jammed"
An original has jammed. See the animated illustration displayed on the
control panel, and remove the jammed
original.
page 451 "When Paper or an Original Is
Jammed"
Paper has run out. Load paper into the paper tray.
page 197 "Loading Paper into the Paper
Tray"
Toner is almost depleted, or has run out. Prepare a replacement toner. Replace the
toner when it runs out.
See "Replacing the Toner", User Guide.
• If appears when there is a lot of toner,
pull out the print cartridge by following
the toner replacement procedure that is
displayed on the screen, and then set it
back again.
The waste toner bottle is full, or almost full. Prepare a replacement waste toner bottle.
Replace the bottle when it becomes full.
See "Replacing the Waste Toner Bottle", User
Guide.
Staples are nearly depleted, or have run
out.
Prepare a cartridge for replacement, and
load it when the staples run out.
See "Replenishing the Staples", User Guide.
The hole punch receptacle is full. Empty the receptacle.
page 466 "When the Hole Punch Receptacle
Is Full"
11. Troubleshooting
366