4. Pinch the end guide and slide it inward to match the standard size.
5. When loading paper into tray 1, slide the two switches at the bottom of the tray
according to the thickness of the paper.
If the paper is heavier than 164 g/m
2
(44 lb.), slide both switches into the rear (thick) position. If
the paper is 163 g/m
2
(43 lb.) or lighter, slide both switches into the forward (thin) position.
6. Set the paper straight down on the paper source tray with its printing side facing up.
Make sure paper is not stacked higher than the upper limit (upper line) marked inside the tray.
Loading Paper
105
To Next Page
Loading...
