Loading Envelopes
• Do not use window envelopes.
• Envelopes, especially those with glue on their flaps, may stick together. Fan the envelopes to
separate them before loading. If the envelopes still stick together, load them one by one. For the
envelope types that can be used with this machine, see page 124 "Supported Paper Sizes and
Types".
• Misfeeds might occur depending on the length and shape of the flaps.
• Load envelopes with their flaps closed. However, load envelopes with their flaps open when the
flaps are opened at the time of purchase.
• When loading envelopes with their flaps open, specify a custom size. You can print with a standard
envelope size setting only when printing on envelopes with their flaps closed.
• Before loading envelopes, press down on them to remove any air from inside, flattening out all four
edges. If they are bent or curled, flattening their leading edges (the edge going into the machine)
by running a pencil or ruler across them.
• To get better output quality, it is recommended that you set the leading- and tailing-edge print
margin to at least 15 mm (0.6 inches), and the left and right margins to at least 10 mm (0.4 inches)
each.
Loading Envelopes into the Bypass Tray
1. While pressing and holding the button in the upper center of the bypass tray, pull the tray
open.
8. Adding Paper and Toner
112