Ricoh SP C360 series - Canceling a Transmission; Canceling a Transmission before the Original Is Scanned; Canceling a Transmission While the Original Is Being Scanned; Canceling a Transmission after the Original Is Scanned

Canceling a Transmission
This section explains how to cancel a fax transmission.
Canceling a Transmission Before the Original Is Scanned
1. Press [Reset] on the top right of the screen.
Canceling a Transmission While the Original Is Being Scanned
Use this procedure to cancel scanning or transmitting of the original while it is being scanned.
If you cancel a transmission using the standard memory transmission function, you need to follow a
different procedure to cancel the transmission. See page 72 "Canceling a Transmission after the
Original Is Scanned".
1. Press [Stop].
2. Press [Cancel].
Depending on the transmission mode and function you use, either [Cancel Scanning] or [Cancel
TX] is displayed.
• Scanning may be completed while you are performing the cancel operation.
Canceling a Transmission after the Original Is Scanned
Use this procedure to cancel a transmission after the original is scanned.
You can cancel transmission of a file while the file is being sent or stored in memory.
1. Press [Job Status].
2. Press [Transmission Standby File].
3. Select [File List] or [Files under Transmission].
4. Select the file you want to cancel.
5. Press [Cancel].
6. Press [OK].
To cancel another file, repeat Steps 4 to 6.
4. Fax
72