Loading Paper into the Bypass Tray
Use the bypass tray to use paper that cannot be loaded in the paper trays.
• For details about trays that can be loaded for each paper size and type, see page 124
"Supported Paper Sizes and Types".
• Make sure the paper stack does not exceed the upper limit mark. Excessive stacking can cause
paper jams.
• Do not mix different types of paper.
• After loading paper, specify the paper size and type using the control panel. When printing a
document, specify the same paper size and type in the printer driver as specified on the printer.
• When loading label paper, load it one by one.
• When printing on paper that is longer than A4 , load only a single sheet of paper on the bypass
tray at a time, and hold the paper so it is fed correctly. Also, make sure to check in advance the
print quality of the type of paper you intend to use. How paper is fed or print quality will differ
depending on the type or thickness of paper.
1. While pressing and holding the button in the upper center of the bypass tray, pull the tray
open.
Pull the extender out when loading paper larger than A4 or 8
1
/
2
× 11 .
8. Adding Paper and Toner
108
To Next Page
Loading...
