Ricoh SP C360 series - Copying an ID Card Using the Exposure Glass

3. If you want to change the card size, press [Change Card Size]. You can select a specified
size or specify a new size.
4. If you want to change the layout, press [Change Layout]. You can select [Vertical Layout]
or [Horizontal Layout].
5. Set the ID card into the ID Card Feeder front side down.
Copying starts automatically.
6. Remove the original, and then press [Finish].
Copying an ID Card Using the Exposure Glass
1. Press [ID Card Copy].
2. Press [ID Card Copy To Next].
3. Press [Change Method of Setting Original].
4. Press [Place on Exposure Glass], and then press [OK].
5. Place the original front side down on the exposure glass.
When copying onto A4 (8
1
/
2
× 11) size paper
Place the original in orientation and in the center of the A5 (5
1
/
2
× 8
1
/
2
) scan area.
DUP468
A5
A5
(8
(8
1
/
2
11
11
)
(5
1
/
2
8
1
/
2
)
6. Press [Start].
7. Place the original back side down on the exposure glass, and then press [Start] again.
8. Remove the original, and then press [Finish].
3. Copy
68