10. Maintenance
This chapter describes how to clean this machine and how to update the machine's firmware.
Maintaining Your Machine
How to Clean the Machine
If the exposure glass or scanning glass is dirty, copy clarity may be reduced. Clean these parts if they
are dirty.
• Do not remove any covers or screws other than those explicitly mentioned in this manual. Inside
this machine are high voltage components that are an electric shock hazard. Contact your sales
or service representative if any of the machine's internal components require maintenance,
adjustment, or repair.
• Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock.
• When performing maintenance on the machine, always disconnect the power cord from the
wall outlet.
• If the machine's interior is not cleaned regularly, dust will accumulate. Fire and breakdown can
result from heavy accumulation of dust inside this machine. Contact your sales or service
representative for details about and charges for cleaning the machine's interior.
• Do not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances
get inside the machine or melt plastic parts, a failure might occur.
• Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
Cleaning the Machine
Wipe the machine with a soft, dry cloth. If this does not remove the dirt, wipe the machine with a
damp and tightly wrung cloth. If a damp cloth still does not remove the dirt, try using a mild
detergent. Wipe the machine with a dry cloth to remove the moisture, after using a damp cloth.
175
To Next Page
Loading...
Need help?
General
