Direction of paper
grain
Paper trays Bypass tray
• Select [Thick Paper 1] or [Thick Paper 2] as the paper thickness in [Tray Paper Settings].
• If [Thick Paper 1] or [Thick Paper 2] is selected, the print speed may change.
• Even if thick paper is loaded as described above, normal operations and print quality might still not
be possible, depending on the paper type.
• Prints might have prominent vertical creases.
• Prints might be noticeably curled. Flatten out prints if they are creased or curled.
• When printing onto thick paper, the print speed changes.
Envelopes
This section gives you various details about and recommendations concerning envelopes.
• Do not use window envelopes.
• Envelopes, especially those with glue on their flaps, may stick together. Fan the envelopes to
separate them before loading. If the envelopes still stick together, load them one by one. For the
envelope types that can be used with this printer, see page 124 "Supported Paper".
• Misfeeds might occur depending on the length and shape of the flaps.
• Load envelopes with their flaps closed. However, load envelopes with their flaps open when the
flaps are opened at the time of purchase.
• When loading envelopes with their flaps open, specify a custom size. You can print with a standard
envelope size setting only when printing on envelopes with their flaps closed.
• Before loading envelopes, press down on them to remove any air from inside, flattening out all four
edges. If they are bent or curled, flattening their leading edges (the edge going into the printer) by
running a pencil or ruler across them.
Supported Paper
129
To Next Page
Loading...
