Rockwell Automation Allen-Bradley PanelView 5310 - Page 27

Rockwell Automation Publication 2713P-UM001G-EN-P - May 2022 27
Chapter 2
Initially, you secure the terminal in the panel by sliding each mounting lever to a
position that is one or two notches greater than the final lock position. For
example, if the final lock position is 1, slide each mounting lever to position 2 or
3. Follow the sequence specific to the terminal size shown in Figure 5 on page 28
.
Figure 4 on page 27
shows the mounting lever orientation and locking sequence
for a 9-in. terminal. See Figure 5 on page 28
for locking sequence and mounting
lever orientations for all terminals.
Figure 4 - Mounting Levers Shown in Locked Position
Flat
Side
Knob on
reverse side
of lever
inserts into
large end of
slot.
12 34
You can use an erasable marker or grease pencil to
mark the indentations for visibility of slot positions.
Inner notch
on lever
shows current
lever position.
Inner
Notch
Outer
Notch
The edge of the bezel has alignment
indentations to assist with the lever position.
The outer notch of the lever shows that the
lever is locked in position 3.
TIP If the lock position is 6, slide the mounting lever to the large end of the slot or
insertion hole.
The notch shows the locked position.
1
All mounting levers are locked in position 4, which is appropriate
for a panel thickness of 3.17…3.66 mm (0.125…0.144 in.).
2
3
4
5
67
8