Digital Modulation SME
1038.6002.02 2.104 E-13
OPERATOR CODE
Input value of the code of the network operator.
IEC-bus command :SOUR:ERM:NINF:OPER 7
PAGING AREA
Input value of the paging area.
IEC-bus command :SOUR:ERM:NINF:PA 4
--- SYSTEM INFORMATION ---
The parameters of the system information set the data of the
transmitting system. These data are included in every message (cf.
ERMES standard).
EXT TRAFFIC INDICATOR
Input value of the External Traffic Indicator Bit.
IEC-bus command :SOUR:ERM:SI:ETI ON
BORDER AREA INDICATOR
Input value of the Border Area Indicator Bit.
IEC-bus command :SOUR:ERM:SI:BAI ON
FREQ SUBSET INDICATOR
Input value of the Frequency Subset Indicator. One-channel
networks have an FSI of 30 according to ERMES standard.
IEC-bus command :SOUR:ERM:SI:FSI 30
DAY OF MONTH
Input value of the date (day of month).
IEC-bus command :SOUR:ERM:SI:DOM 24
TIME
Input value of the time.
IEC-bus command :SOUR:ERM:SI:TIME 12,59
--- MESSAGE ---
The parameters of this section set the destination address and
determine the message data.
INITIAL ADDRESS
Input value of the address of the pager. Every receiver has an own,
nonrecurring address.
IEC-bus command :SOUR:ERM:MESS:IA 0
CATEGORY
Selection of the message category.
TONE Tone-only message
NUMERIC Numeric message
ALPHANUMAlphanumeric message
IEC-bus command :SOUR:ERM:MESS:CAT TONE
TONE NUMBER
Input value of the tone transmitted with message category TONE. 16
tones (8 normal, 8 urgent) are available.
IEC-bus command :SOUR:ERM:MESS:TONE 1
NUMERIC MESSAGE
Input of the character string for a numeric message. The SME
maximally provides 16 digits. In addition to the 10 digits "0" to "9",
the signs forward slash "/", upper-case letter "U", hyphen "-", period
".", percent "%" and blank can be used.
IEC-bus command :SOUR:ERM:MESS:NUM "12% 12-17"
To Next Page
Loading...
