Rohde & Schwarz SME02 - Source 0|2:Function-Subsystem

SME SOURce0|2:FUNCtion
1038.6002.02 3.111 E-13
3.6.12.2 SOURce 0|2:FUNCtion-Subsystem
This subsystem contains the commands specifying the waveform of the output signal.
Command Parameter Default
Unit
Remark
:SOURce0|2
:FUNCtion
[:SHAPe]
SINusoid | SQUare | TRIangle | PRNoise |
SAWTooth
Option SM-B2 / B6
Option SM-B6
:SOURce0|2:FUNCtion[:SHAPe] SINusoid | SQUare | TRIangle | PRNoise | SAWTooth
The command specifies the waveform of the output signal. In the case of the standard generator,
the waveform is specified to be sine. Option SM-B2, LF generator can be converted to the signal
forms sine, square, triangle and periodic noise, option SM-B6, multifunction generator to all signal
forms. If two options SM-B2 are installed, SOURce0 can be set to the signal forms of option
SM-B2 as well.
SINusoid Sine
SQUare Square
TRIangle Triangle
PRNoise Periodic noise
SAWtooth Sawtooth *RST value is SIN
Example: :SOUR2:FUNC:SHAP SQU