SOURce:STEReo SME
1038.6002.02 3.100 E-13
3.6.11.20 SOURce:STEReo Subsystem
This subsystem contains the commands to generate FM stereo multiplex signals conforming to
standards according to the pilot-tone method (options SM-B5 and SM-B6). The modulation signal is
output in addition at the LF output socket (cf. Section "OUTPut2 system" as well).
Command Parameter Default
Unit
Remark
[:SOURce]
:STEReo
:STATe
[:DEViation]
:SIGNal
:AUDio
[:FREQuency]
:PREemphasis
:MODE
:PILot
:STATe
[:DEViation]
:PHASe
:ARI
[:DEViation]
:TYPE
:BK
[:CODE]
ON | OFF
0 Hz to 100 kHz
AUDio | ARI
0.1 Hz to 15 kHz
OFF | 50 us | 75 us
RIGHt | LEFT | RELeft | REMLeft
ON | OFF
0 Hz to 10 kHz
0 to 360 deg
0 Hz to 10 kHz
BK | DK | OFF
A | B | C | D | E | F
Hz
Hz
Hz
rad
Hz
Option SM-B6 and
SM-B5
[:SOURce]:STEReo:STATe ON | OFF
The command switches on or off the stereo signal. *RST value is OFF
Example: :SOUR:STER:STAT ON
[:SOURce]:STEReo[:DEViation] 0 Hz to 100 kHz
The command sets the frequency deviation of the FM stereo multiplex signal without considering
the pilot-tone content.
Example: :SOUR:STER:DEV 40kHz *RST value is 40 kHz
[:SOURce]:STEReo:SIGNal AUDio | ARI
The command selects which signals are generated, simulated audio signals or ARI traffic channel
signals with a 19-kHz pilot tone.
AUDio Audio signals are generated, ARI is switched off.
ARI ARI signals are generated.
Example: :SOUR:STER:SIGN AUD *RST value is AUDio
To Next Page
Loading...
