Utilities SME
1038.6002.02 2.154 E-13
2.11.3 Suppressing Indications and Deleting Memories (SYSTEM-SECURITY)
For security interests, indications can be suppressed and memories deleted in the SYSTEM-SECURITY
submenu.
Menu selection: UTILITIES - SYSTEM-SECURITY
FREQUENCY
LEVEL
MODULATION
DIGITAL MOD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
HELP
SYSTEM
REF OSC
PHASE
PROTECT
CALIB
DIAG
TEST
MOD KEY
AUX I/O
BEEPER
INSTALL
STATE
OFF ON
ANNOTTATION FREQ OFF ON
ANNOTTATION AMPLITUDE OFF ON
CLEAR MEMORY
FREQ
100. 000 000 0
MHz
LEVEL
-30.0
dBm
GPIB
RS232
SECURITY
LANGUAGE
Fig. 2-65 Menu UTILITIES - SYSTEM-SECURITY
STATE
Selection of the SECURITY state
ON Locks the suppression of the indications. Can only be
set via IEC bus.
OFF Deactivates the interlock of the indication
suppression. The preset state is set in the transition
ON
→
OFF, and all data stored such as settings, with
the exception of the DM lists are deleted. Can only
be set via IEC bus.
IEC-bus short command :SYST:SEC OFF
ANNOTATION FREQ
OFF All frequency indications are suppressed.
ON The frequency setting is displayed.
.
IEC-bus short command :DISP:ANN:FREQ ON
ANNOTATION AMPLITUDE
OFF All level indications are suppressed.
ON The level setting is displayed.
IEC-bus short command :DISP:ANN:AMPL ON
CLEAR MEMORY Ð
Deletion of all data stored such as settings, user correction and
list settings stored, with the exception of the DM lists.
For this action, two commands are necessary at the IEC bus:
IEC-bus short command :SYST:SEC ON; SEC OFF
To Next Page
Loading...
