Rohde & Schwarz SME02 - RF Frequency; Fig. 2-16 Menu FREQUENCY (Preset Setting)

SME RF Frequency
1038.6002.02 2.41 E-13
2.4 RF Frequency
The frequency of the RF output signal can be set directly using the [FREQ] key (cf. Section 2.2.2.5) or
by accessing menu FREQUENCY.
In the FREQUENCY menu, the frequency of the RF output signal is indicated under FREQUENCY.
In the case of frequency settings effected in the FREQUENCY menu, the value entered directly is the
frequency of the RF output signal.
The input value of frequency settings opened by means of the [FREQ] key considers the offset in
calculation (cf. next Section). This offers the possibility of entering the desired output frequency of
possibly series-connected instruments such as mixers in the menu.
Note: Further settings: Frequency sweep Menu SWEEP
LF frequency Menu MODULATION
Menu LF-OUTPUT
int./ext. reference frequency Menu UTILITIES-REF OSC
Phase of the output signal Menu UTILITIES-PHASE
Menu selection: FREQUENCY
FREQUENCY
LEVEL
MODULATION
DIGITAL MOD
LF OUTPUT
SWEEP
LIST
MEM SEQ
UTILITIES
HELP
FREQUENCY
OFFSET
KNOB STEP USER
KNOB STEP
EXCLUDE FROM RCL
100. 000 000 0 MHz
0.0 Hz
FREQ
100. 000 000 0
MHz LEVEL
- 30.0
dBm
1. 000 000 0 MHz
DECIMAL USER
ON OFF
Fig. 2-16Menu FREQUENCY (preset setting)
FREQUENCY
Input value of the RF frequency considering the OFFSET input value. The
frequency of the RF output signal is determined by input values FREQUENCY
and OFFSET (cf. Section 2.4.1 Frequency Offset).
IEC-bus command SOUR:FREQ 100E6
OFFSET
Input value of the frequency offset, e.g., of a series-connected mixer (cf.
Section 2.4.1, Frequency Offset).
IEC-bus command SOUR:FREQ:OFFS 0
KNOB STEP USER
Input value of the step width for frequency variation using the rotary knob. The
RF frequency is varied in the step width entered if KNOB STEP is set to USER.
IEC-bus command SOUR:FREQ:STEP 1MHz