Rohde & Schwarz SME02 - Use of [FREQ] and [LEVEL] Keys; Use of [RF on; OFF] and [MOD on; OFF] Keys; Changing Unit of Level

Basic Operating Steps SME
1038.6002.02 2.22 E-13
2.2.3.5 Use of [FREQ] and [LEVEL] Keys
RF frequency and RF level can be set without menu operation as well using direct keys [FREQ] and
[LEVEL]. The input value considers the offset, see Sections 2.4 and 2.5.
Key [FREQ]/ [LEVEL] À Press the [FREQ] or [LEVEL] key.
The frequency and/or the level indication in the header field of the display
is marked.
The current menu at the display is maintained.
À Alter the value via a value input or the rotary knob.
À Press the [RETURN] key.
The menu cursor wraps to the position marked last in the menu.
2.2.3.6 Use of [RF ON / OFF] and [MOD ON / OFF] Keys
RF signal and modulation can be switched on/off without menu operation as well using direct keys
[RF ON / OFF] and/or [MOD ON / OFF] (see Section 2.6.1.3, [MOD ON/OFF] key as well).
Key [RF ON / OFF] À Press the [RF ON / OFF] key.
The RF output signal is switched on/off.
IEC-bus command: :OUTP:STAT ON
Key [MOD ON / OFF] À Press the [MOD ON / OFF] key.
The modulation is switched on/off.
A direct IEC-bus command is not available. The modulations have to be
switched on and off in the respective modulation submenus.
2.2.3.7 Changing Unit of Level
For the level, the unit of the value set can be changed without a new value input.
Change level unit À Activate LEVEL parameter.
- Press the [LEVEL] key or
- set the menu cursor in the LEVEL menu to the setting value of the
AMPLITUDE parameter.
À Press the unit key with the desired level unit.
The level is indicated in the desired unit.