Sweep SME
1038.6002.02 2.142 E-13
START FREQ
Input value of the starting frequency.
IEC bus short command :SOUR:SOUR2:FREQ:STAR 100kHz
STOP FREQ
Input value of the stop frequency.
IEC bus short command :SOUR2:FREQ:STOP 50kHz
CURRENT FREQ
Indication of the current frequency value.
Operating mode STEP: Input value of the frequency.
STEP
Input value of the step width.
IEC bus short command :SOUR2:SWE:STEP:LIN 1kHz
DWELL
Input value of the dwell time per step.
IEC bus short command :SOUR2:SWE:DWEL 15ms
SPACING
Selection of the sweep run, linear or logarithmic.
IEC bus short command :SOUR2:SWE:SPAC LIN
MODE
Selection of the sweep operating mode (cf. Section 2.8.3).
IEC bus short command :SOUR2:FREQ:MODE SWE
:SOUR2:SWE:MODE AUTO
:TRIG2:S:SOUR OUR SING
EXECUTE SINGLE SWEEP Ð
Starts a single sweep run. This action to be executed is only indicated
and is only effective if MODE SINGLE is selected.
IEC bus short command :TRIG
RESET SWEEP Ð
Sets the starting frequency.
IEC bus short command :ABOR
MARKER 1 FREQ
MARKER 2 FREQ
MARKER 3 FREQ
Input value of the frequency for the marker selected.
IEC bus short command :SOUR2:MARK1:FREQ 1kHz
MARKER 1 STATE
MARKER 2 STATE
MARKER 3 STATE
Switching on/off the marker selected.
IEC bus short command :SOUR2:MARK1 OFF
To Next Page
Loading...
