SME SOURce:FLEX
1038.6002.02 3.57 E-133
[:SOURce]:FLEX:ERRor:WORD 0 to 87
The command determines the position of the word to be falsified. The words are numbered from
block 0, word 0 to block 10, word 7 of a frame. The sync part and the frame information word
cannot be falsified. The falsification precedes block interleaving in all transmitted phases.
Example: :SOUR:FLEX:ERRor:WORD 0 *RST value is 0.
[:SOURce]:FLEX:FCONtent "X | blank spaces | O | A [,X| blank spaces | O| A]"
This command determines the contents of the 128 frames. Each frame is represented by a
character. If less than 128 values are indicated, the output cycle is shortened correspondingly.
X Flex useful data
SpaceFlex filler data
O Simulated data of another radiocommunication service (O for OTHER)
A "Emergency Resynchronization" specified in the FLEX standard (A stands for ASYNC)
The frame assigned to the pager is calculated from the value of FLEX:MESSage:CAPCode
according to the following formula:
Frame = (Integer(CAPCODE/16)) modulo 128
Notes: - The SINFormation:COLLapse value may cause the pager to respond to much
more than merely its "own" frame.
- As the FLEX signal generation is subject to the trigger system, the settings under
TRIGger:DM, determine whether the specified frame contents or only the filler
frames are output.
Example: :SOUR:FLEX:FCON "X, , ,O,O,O,O,O,X,X,X,A,A,A, ,X"
[:SOURce]:FLEX:FCONtent:AUTO ON | OFF
This command determines the influence of changes of CAPCODE on FRAME CONTENT.
ON FRAME CONTENT is set so that in all frames evaluated by the reciever (and only in
those) FLEX data are also transmitted. All the other frames only contain filler data.
OFF A change of CAPCODE has no influence on FRAME CONTENT.
Example: :SOUR:FLEX:FCON:AUTO ON *RST value is ON
[:SOURce]:FLEX:MODulation 1600, FSK2 | 3200, FSK2 | 3200,FSK4 | 6400,FSK4
The command determines the used bit rate and modulation. FLEX recognizes four modulations:
1600bps/2FSK 3200bps/2FSK 3200bps/4FSK 6400bps/4FSK
Example: :SOUR:FLEX:MOD 1600,FSK2 * RST value is 1600,2FSK
To Next Page
Loading...
