SOURce:FLEX SME
1038.6002.02 3.62 E-13
[:SOURce]:FLEX:SI|SINFormation: CZONe 0 to 31
This command determines the coverage zone. *RST value is 0
Example: :SOUR:FLEX:SI:CZON 0
[:SOURce]:FLEX:SI|SINFormation: STMF 0 to 31
The command allows the entry of any input value of the four traffic management flags for SSID.
IEC-bus command: :SOUR:FLEX:SINF:STMF 15 *RST value is 15
[:SOURce]:FLEX:SI|SINFormation: DATE Year, month, day
The command sets the date. *RST value is 1994,01,01
Example: :SOUR:FLEX:SI:DATE 1994,01,01
[:SOURce]:FLEX:SI|SINFormation: FOFFset 0 to 63
The command sets the input value of the frame offsets.
IEC-bus command: :SOUR:FLEX:SINF:FOFFset 0 *RST value is 0
[:SOURce]:FLEX:SI|SINFormation: LID 0 to 511
The command sets the input value of the local ID.
IEC-bus command: :SOUR:FLEX:SINF:LID 0 *RST value is 0
[:SOURce]:FLEX:SI|SINFormation: NADDress 2058240 to 20622335
Input value of the network address part of the network ID.
IEC-bus command: :SOUR:FLEX:SINF:NADD 2058240 *RST value is 2058241
[:SOURce]:FLEX:SI|SINFormation: NTMFlags 0 to 15
The command sets the input value of the four traffic management fags for NID
IEC-bus command: :SOUR:FLEX:SINF:NTMF 15 *RST value is 0
[:SOURce]:FLEX:SI|SINFormation: SARea 0 to 31
The command sets the input value of the service area part of the network ID.
IEC-bus command: :SOUR:FLEX:SINF:SAR 0 *RST value is 15
[:SOURce]:FLEX:SI|SINFormation: TIME 00,00 to 23,59
This command sets the time. *RST value is 12,00
Example: :SOUR:FLEX:SI:TIME 12,00
[:SOURce]:FLEX:TACTion MESSage | STARt | ONCE
This command (Trigger ACT
ion) determines the action which is activated by a trigger event. The
valid trigger events are specified by command TRIGger:DM:SOURce. This command also
defines the allocation between manual and remote-control operations.
MESSage A trigger event switches from filler data output to useful data output for the duration
of a batch (1.875 s). The filler data are then output again.
STARt Digital modulation is started by a trigger event. Useful data are then continuously
output according to the settings. This setting is suitable, for example, for a
synchronous start of several units.
ONCE The output of the FLEX telegram is only started by a valid trigger event. After
recognition of this signal, exactly one frame is output in the way it has been set
under :FLEX:FCONT. After that, the SME waits for its trigger pulse again (defined
under TRIG:DM:SOUR).
Example: :SOUR:FLEX:TACT MESS *RST value is MESSage
To Next Page
Loading...
