TRIGger SME
1038.6002.02 3.128 E-13
:TRIGger:PULSe:SOURce EXTernal | AUTO
The command specifies the trigger source.
EXTernal Triggering is effected from outside via the PULSE socket.
AUTOTrigger is free-running (see above) *RST value is AUTO
Example: :TRIG:PULS:SOUR AUTO
:TRIGger:PULSe:SLOPe POSitive | NEGative
The command indicates whether the action triggered is triggered at the positive or the negative
edge of the trigger signal. *RST value is POSitiv
Example: :TRIG:PULS:SLOP NEG
:TRIGger:SLOPe POSitive | NEGative
The command indicates whether the external trigger input only responds to the positive, the
negative or to both edges of the trigger signal. The command acts on TRIGger:SWEep,
TRIGger:LIST and TRIGger:MSEQuence. The pulse generator has an own trigger input and thus
also an own SLOPe command. *RST value is POSitiv
Example: :TRIG:SLOP NEG
To Next Page
Loading...
