SME Contents
1039.1856.12 5 E-13
2.6.3.8 FSK Modulation......................................................................................... 2.94
2.6.3.9 4FSK Modulation....................................................................................... 2.97
2.6.3.10 FFSK Modulation..................................................................................... 2.100
2.6.3.11 Radiocommunication Service ERMES.................................................... 2.102
2.6.3.12 Radiocommunication Service FLEX........................................................ 2.107
2.6.3.13 Radiocommunication Service ReFLEX25............................................... 2.116
2.6.3.14 Radiocommunication Service POCSAG ................................................. 2.127
2.7 LF-Output ........................................................................................................................... 2.132
2.8 Sweep ................................................................................................................................. 2.134
2.8.1 Setting the Sweep Range (START, STOP, CENTER and SPAN) ......................... 2.134
2.8.2 Selecting the Sweep Run (SPACING LIN, LOG).................................................... 2.135
2.8.3 Operating Modes (MODE)...................................................................................... 2.135
2.8.4 Trigger Input ........................................................................................................... 2.136
2.8.5 Sweep Outputs ....................................................................................................... 2.136
2.8.6 RF-Sweep............................................................................................................... 2.138
2.8.7 LEVEL Sweep......................................................................................................... 2.140
2.8.8 LF-Sweep................................................................................................................ 2.141
2.9 LIST Mode .......................................................................................................................... 2.143
2.9.1 Operating Modes (MODE)...................................................................................... 2.143
2.9.2 Inputs/Outputs ........................................................................................................ 2.144
2.10 Memory Sequence............................................................................................................. 2.148
2.11 Utilities................................................................................................................................ 2.152
2.11.1 IEC-Bus Address (SYSTEM-GPIB) ........................................................................ 2.152
2.11.2 Parameter of the RS232 Interface (SYSTEM-RS232) ........................................... 2.153
2.11.3 Suppressing Indications and Deleting Memories (SYSTEM-SECURITY).............. 2.154
2.11.4 Indication of the IEC-Bus Language (LANGUAGE)................................................ 2.155
2.11.5 Reference Frequency Internal/External (REF OSC)............................................... 2.155
2.11.6 Phase of the Output Signal (PHASE) ..................................................................... 2.156
2.11.7 Password Input With Functions Protected (PROTECT)......................................... 2.157
2.11.8 Calibration (CALIB)................................................................................................. 2.158
2.11.9 Indications of Module Variants (DIAG-CONFIG) .................................................... 2.162
2.11.10 Voltage Indication of Test Points (DIAG-TPOINT) ................................................. 2.163
2.11.11 Indications of Service Data (DIAG-PARAM)........................................................... 2.164
2.11.12 Test (TEST) ............................................................................................................ 2.164
2.11.13 Assigning Modulations to the [MOD ON/OFF] Key (MOD-KEY)............................. 2.165
2.11.14 Setting Auxiliary Inputs/Outputs (AUX-I / O)........................................................... 2.166
2.11.15 Switching On/Off Beeper (BEEPER) ...................................................................... 2.167
2.11.16 Installation of Software Option................................................................................ 2.168
2.12 The Help System................................................................................................................ 2.169
2.13 Status.................................................................................................................................. 2.169
2.14 Error Messages.................................................................................................................. 2.170
To Next Page
Loading...
