RF Level SME
1038.6002.02 2.44 E-13
LIMIT
Input value of level limitation. This value indicates the upper limit of the level at
the RF output connector. If a level above this limit is attempted to be set, a
warning is displayed in the status line.
IEC-bus command SOUR:POW:LIM 16 dBm
ATTENUATOR MODE
AUTO Normal operation. The attenuator switching mechanically switches
in steps of 5 dB, the switching points being fixed.
IEC-bus command :OUTP:AMOD AUTO
FIXED Level settings are effected without switching the attenuator (cf.
Section 2.5.2, Interrupt-free Level Setting).
IEC-bus command :OUTP:AMOD FIX
ATTEN FIXED RANGE
Indication of the level range in which the level is set without interruption in the
"ATTENUATOR MODE FIXED" operating mode.
KNOB STEP USER
Input value of the step width for level variation using the rotary knob. The RF
level is varied in the step width entered if KNOB STEP is set to USER.
IEC-bus command SOUR:POW:STEP 1
KNOB STEP
DECIMAL Variation step width according to the position of the digit cursor.
USER User Defined, variation step width as entered under KNOB STEP
USER.
POWER RESOLUTION
Selection of resolution of LEVEL display. For level range -99.9 dBm to +16
dBm the resolution for the level display can be set to 0.1 dB or 0.01 dB.
POWER-ON STATE
Selection of the state the RF output is to assume after power-on of the unit
RF OFF Output is switched off
PREVIOUS SETTING Same state as before switch-off
IEC-bus command :OUTP:PON ON
EXCLUDE FROM RCL
OFF The saved RF level is loaded as well when instrument settings are
loaded with the [RCL] key or with a memory sequence.
IEC-bus command SOUR:POW:RCL INCL
ON The RF level is not loaded when instrument settings are loaded,
the current level settings are maintained.
IEC-bus command SOUR:POW:RCL EXCL
To Next Page
Loading...
