Rohde ST411 - English

42 / 280
Instruction Manual ST 410/ST 411
Table of Contents
1. Introduction ...................................................................................................................................................... 44
1.1. Preface .............................................................................................................................................................. 44
1.2. Contact ............................................................................................................................................................. 44
1.3. Scope of delivery ............................................................................................................................................... 44
2. Control unit description ..................................................................................................................................... 45
2.1. Product features ................................................................................................................................................ 45
2.2. Technical information ......................................................................................................................................... 45
2.3. Control unit overview ......................................................................................................................................... 46
2.4. Connector features ............................................................................................................................................ 47
2.5. Plug pin assignment .......................................................................................................................................... 47
2.6. Kiln contactor protection circuit ......................................................................................................................... 47
3. Safety instructions ............................................................................................................................................ 48
4. Mounting .......................................................................................................................................................... 49
4.1. Mounting the bracket ........................................................................................................................................ 49
4.2. Connecting the connection cable ...................................................................................................................... 49
4.3. Control unit extension cable .............................................................................................................................. 49
4.4. Third-party kiln note ........................................................................................................................................... 49
5. Installation ........................................................................................................................................................ 50
5.1. Switching the control unit on & off ..................................................................................................................... 50
5.2. Quick start guide ............................................................................................................................................... 50
6. Operation & use ................................................................................................................................................ 50
6.1. Keylock ............................................................................................................................................................. 50
6.2. Display screens after switching on ..................................................................................................................... 51
6.3. Firing segments ................................................................................................................................................. 51
6.3.1. Explanation of firing segments ............................................................................................................ 51
6.3.2. Example of a firing program to illustrate the firing segment ................................................................. 52
6.4. Programming the control unit ............................................................................................................................ 53
6.4.1. Changing the firing program ............................................................................................................... 53
6.4.2. Changing the firing program: Programming the heating or cooling ramp ............................................ 54
6.4.3. Programming the “FULL” & “END” ramp rates ................................................................................... 56
6.5. Programming the additional switch output (ST 411 only) ................................................................................... 57
6.5.1. General description (ST 411 only) ....................................................................................................... 57
6.5.2. Configuring parameters for switch output (ST 411 only) ..................................................................... 57
6.5.3. Possible assignment of the switch output (ST 411 only) ..................................................................... 57
6.5.4. Event programming (ST 411 only) ...................................................................................................... 57
6.5.5. Programming the exhaust air flap (ST 411 only) ................................................................................. 58
6.5.6. Programming the cooling system (ST 411 only) ................................................................................. 59
6.6. Firing ................................................................................................................................................................. 61
6.6.1. General operation............................................................................................................................... 61
6.6.2. Operation using the
j ...................................................................................................................... 62
6.6.3. Program delay .................................................................................................................................... 62
6.6.4. Program advance facility .................................................................................................................... 62
6.6.5. Program pause facility ........................................................................................................................ 62
6.7. Querying kiln performance ................................................................................................................................. 63
6.8. Cooling .............................................................................................................................................................. 63
EN