Roland MV-8800

M-135
MV-8800 Owner’s Manual
Using the sequencer
8
Using the velocity pads to switch Track Mute and Solo
Here’s how to use the velocity pads to switch Mute (silenced) and Solo settings on/off for a track.
1.
Hold down [SHIFT], and press [PAD BANKS].
The TRACK MUTE screen (Screen Guide; p. 75) will appear.
fig.trackmute-screen.eps
2.
Press [F1](Mute) to switch the mute setting of a track, or press [F2](Solo) to switch the solo
setting.
The TRACK MUTE screen will appear if you press [F1](Mute). The TRACK SOLO screen will appear if you
press [F2](Solo).
3.
Use value dial or [DEC] [INC] to set the Track Bank parameter.
Track Banks divide tracks 1–136 into groups of sixteen tracks. Select the track bank containing the tracks you
want to mute or solo.
4.
Strike the VELOCITY PADS.
The track corresponding to the velocity pad you struck will be muted or soloed.
Muted tracks are indicated by the “MUTE” icon, and the pad will be displayed in dark gray. Soloed tracks are
indicated by the “SOLO” icon, and the pad is displayed in white.
fig.trackmute-screen.eps
5.
Press [EXIT] to exit the TRACK MUTE screen or TRACK SOLO screen.
● The velocity pads of track banks 1–9 are displayed in miniature at the right of the Track Bank parameter to
indicate the current mute and solo settings.
● You can record the operation of muting and soloing tracks to the sequencer. For details, refer to “Recording
mute operations” (p. 221).
MUTE Icon SOLO Icon Normal
MV-8800_e.book 135 ページ ２００６年１１月１０日 金曜日 午後１時４８分