M-83
MV-8800 Owner’s Manual
3
Sampling
Chapter 3
Sampling
Here’s how to record (sample) from a connected external mic or synthesizer, and use the sample as an audio source for the
MV-8800’s sampler.
Making initial settings for sampling
●
To adjust the sensitivity and level of the analog input
1.
Press [MIXER].
The MIXER screen will appear.
2.
Press [F4](AUX/Phrs/In).
The MIXER (AUX/FX/AUDIO PHRASE/INPUT) screen (Screen Guide; p. 237) will appear.
3.
Set the Level of IN channel to 100 by using Slider 8.
4.
Input an audio signal to the ANALOG INPUT
MIC/LINE (
or ANALOG INPUT PHONO) jacks.
The level meter will move.
5.
Adjust the SENS L/R knobs.
Adjust the knobs so that the level meters move as high as possible in the range of -12 dB–0 dB. If the clip
indicators light, the level is too high.
●
If you’re recording an analog input source, adjust the recording level before sampling.
-12–0 dB
Clip
indicators
MV-8800_e.book 83 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
