M-208
MV-8800 Owner’s Manual
Adjusting the tone of an instruments or audio track
Each part of instruments and the mixer section of each audio track has a 3-band EQ (equalizer).
You can use the equalizer to adjust the tone.
1.
Press [MIXER].
The MIXER screen will appear.
2.
Press the function buttons to switch the mixer you want to adjust tones by equalizer.
3.
Press [F4](
➔
EQ)
The screen will show the EQ screen for the mixer you select in step 2.
4.
Use CURSOR [ ] [ ] [ ] [ ] to move the cursor to the equalizer parameter on which
you want to adjust.
5.
Use the VALUE dial or [INC] [DEC] to adjust.
The value of the selected parameter will change.
F-button
Screen displays
[F1](Audio Track)
MIXER (AUDIO TRACK) screen (Screen Guide; p. 235)
[F2](Part 1–8) MIXER (INSTRUMENT PART 1–8) screen (Screen Guide; p. 236)
[F3](Part 9–16) MIXER (INSTRUMENT PART 9–16) screen (Screen Guide; p. 236)
●
The mixer screen accessed by pressing [F4](AUX/Phrs/In) does not have an equalizer function.
Mixer selected
Screen displayed
Audio Track
MIXER (AUDIO TRACK EQ) screen (Screen Guide; p. 238)
Part 1–8 MIXER(INSTRUMENTS PART 1-8 EQ) screen (Screen Guide; p. 239)
Part 9–16 MIXER(INSTRUMENTS PART 9-16 EQ) screen (Screen Guide; p. 239)
●
Pressing [F5](
➔
EQ) will display the EQ screen, and pressing [F5](
➔
Level/Pan) will display the MIXER screen.
The [F5](
➔
EQ) and [F5](
➔
Level/Pan) functions will alternate each time you press the button.
●
While the EQ screen is displayed, repeatedly pressing [MIXER] will cycle through the screens in the following
order:
MIXER (AUDIO TRACK)
➔
MIXER (INSTRUMENTS PART 1–8)
➔
MIXER (INSTRUMENTS PART 9–16)
➔
MIXER (AUDIO TRACK)
●
For details on the equalizer parameters, refer to each MIXER EQ screen.
MV-8800_e.book 208 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
