Roland MV-8800

M-312
MV-8800 Owner’s Manual
Using the MV-8800 to operate an external V-LINK device (V-LINK Master)
● Connections with the Edirol PR-50
Connect the MV-8800’s MIDI OUT connector via an Edirol UM-1EX etc. to the Edirol PR-50’s REMOTE connector.
● Connections with the Edirol MD-P1
Use a MIDI cable to connect the MV-8800’s MIDI OUT connector to the Edirol MD-P1’s MIDI IN connector.
1.
Press [V-LINK].
[V-LINK] will light blue, and the V-LINK function will be turned On (i.e., V-LINK will be available). You can
operate the MV-8800’s pads to control the images in synchronization with your performance on the MV-8800.
2. Press [V-LINK] once again.
[V-LINK] will go dark, and the V-LINK function will be turned Off (normal operating mode).
1.
Press [SYSTEM].
The SYSTEM MENU screen (Screen Guide; p. 172) will appear.
2. With the cursor located in the upper row of icons, press [F4](V-Link). Alternatively, select
the V-LINK icon and press [ENTER].
The V-LINK screen (Screen Guide; p. 179) will appear.
Example connections
● Before you make connections, you must turn down the volume of all devices and turn off the power to avoid
malfunctions or speaker damage.
Switching V-LINK on/off
● When you press [V-LINK] on the MV-8800, it will operate as the “V-LINK master” which controls an external
V-LINK device.
Making V-LINK settings
Edirol PR-50
Display
Edirol UM-1EX
Projector
MIDI OUTA or B
REMOTE
MV-8800
MIDI OUT A or B
MV-8800
Edirol MD-P1
Computer
MIDI IN USB
MV-8800_e.book 312 ページ ２００６年１１月１０日 金曜日 午後１時４８分