Roland MV-8800

Editing events individually
M-186
MV-8800 Owner’s Manual
Here you can make detailed settings for the pattern event in a pattern track.
1.
Press [SONG].
The SONG screen (Screen Guide; p. 8) will appear.
2. Press [F5](Seq Edit).
The SEQUENCE EDIT screen (Screen Guide; p. 31) will appear.
3.
Use CURSOR [ ] [ ] to select the pattern track containing the pattern event you want to
edit.
4.
Use [JUMP] + MEAS [ ] [ ] to move to the time location of the pattern event.
5.
Press [MENU].
The MENU popup will appear.
6.
Select “Pattern Parameter...” and press [F5](Select).
The PATTERN EVENT PARAMETR popup (Screen Guide; p. 112) will appear.
fig.pattern-step-rec.eps
• [F1](Move)
MOVE PATTERN EVENT popup will appear. This lets you change the Position at which the pattern will play,
and the Duration for which it will play.
• Track
This Displays the number and name of the track you are editing.
• Pattern
This lets you change the pattern at the current time location to a different pattern you specify.
Range: 001–The current pattern number–500
• Start
This lets you specify the time location from which the pattern will begin playing.
Range: 0001-01-000–The end of pattern
• Position
This displays the starting location (measure - beat - tick) at which the pattern is recorded. If you want to edit
this parameter, press [F1](Move).
• Duration
This indicates the actual length (beats - ticks) for which the pattern will play. If you want to edit this parameter,
press [F1](Move).
7.
Press [F5](Close).
Pattern event parameter
MV-8800_e.book 186 ページ ２００６年１１月１０日 金曜日 午後１時４８分