Roland MV-8800

List of available editing commands
M-200
MV-8800 Owner’s Manual
Here’s how you can “clip” the performance data of the specified region and save it in the library as MIDI clip
data.
❍ Parameters to specify
• Name
By default, the clip will have a name consisting of the track name and a two-digit number. You can change this
name as desired. To rename the clip, press [F1](Name) to open the EDIT MIDI CLIP NAME popup (Screen
Guide ;p. 3).
Here’s how you can copy the specified region of the current song as a new pattern.
❍ Parameters to specify
• Name
This shows the name of the pattern selected by the cursor.
• No.
This shows the number of the registered pattern. You can register five hundred patterns, 001–500. Use the
VALUE dial to select the pattern number that you want to register.
● For details on all of the parameters and values of the Copy As MIDI Clip command, refer to “COPY AS MIDI
CLIP popup” (Screen Guide; p. 44).
● The number of clips you can save will depend on the size of the song / pattern and the size of the MIDI clips.
● If you use the VIEW FILTER popup (Screen Guide; p. 53) to restrict the types of event, only the specified type(s)
of events will be saved as a MIDI clip.
● MIDI clips saved in the library can be used in other songs / pattern. For details, refer to “PASTE MIDI CLIP
popup” (Screen Guide; p. 47).
● For details on all of the parameters and values of the Copy As New Pattern command, refer to “COPY AS NEW
PATTERN popup” (Screen Guide; p. 105).
● You can save a region of a pattern as an another pattern.
● If the length of the selected region exceeds 999 measures, it cannot be saved to a new pattern.
● If you select a pattern that’s not empty, “Overwrite Sure?” message will appear. If you press [F5](Yes), the newly
saved data will overwrite that pattern.
Saving a portion of performance data in the library
(Copy As MIDI Clip)
Saving a region of a song as a pattern (Copy As New Pattern)
MV-8800_e.book 200 ページ ２００６年１１月１０日 金曜日 午後１時４８分