M-143
MV-8800 Owner’s Manual
Using the sequencer
8
Using the velocity pads to play patterns
You can use the velocity pads to play patterns in succession. This is a useful way to check the transitions
between patterns.
1.
Press [PATTERN].
The PATTERN screen (Screen Guide; p. 91) will appear.
2.
Press [F1](Pattern List).
The PATTERN LIST screen (Screen Guide; p. 96) will appear.
3.
Press [F1](Pattern Play).
The PATTERN PLAY screen (Screen Guide; p. 98) will appear.
•
Cur:
Indicates the currently-playing pattern.
•
Next:
Specifies the pattern that will be played as soon as the currently-playing pattern has finished playing.
Range: 001–500
•
Use Pattern Tempo
Specifies the playback tempo of the pattern.
•
[F1](Wait)
In this playback mode, the pattern specified for Next: will be selected when the pattern indicated for Cur: has
finished playing.
•
[F2](Immedicate)
In this playback mode, the pattern will change immediately when you change the pattern specified for Next:.
•
[F5](Ptn
↔
APhrs)
Specifies whether the velocity pads will play patterns or audio phrases.
PadBank indicates what the velocity pads will play.
4.
Press [PLAY ( )].
Pattern playback will begin. The Cur: field indicates the pattern that is now playing.
5.
While the pattern is playing, use the Next: parameter or VELOCITY PADS to select the
pattern you want to play next.
•
If the playback mode is Wait
If it finishes playing Cur: (current) pattern, it will change to the Next; pattern.
•
If the playback mode is Immediate
The pattern changes at the same time it changes a value of the Next: parameter.
Value Explanation
Off The pattern will play at the tempo of the song.
On (
✔
) The pattern will play at the tempo specified for that pattern.
●
If you want to assign a pattern to a pad, refer to “Assigning a pattern to a pad” (p. 144).
●
You can also set the Next parameter by striking a velocity pad.
●
If you select a (Empty) pattern for Next, the playing pattern will not change.
MV-8800_e.book 143 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
