Roland MV-8800

List of available editing commands
M-198
MV-8800 Owner’s Manual
You can enter automation data (p. 3) containing values that change continuously over time, such as Volume
data or Pan data.
❍ Parameters to specify
• Event
Specify the type of data that you want to enter.
• Number
Specify the Control Change number that you want to enter, if you specified Control Change as the Event.
• Note
Specify the Note number that you want to enter, if you specified Poly Aftertouch as the Event.
• Value From
Specify the initial value at the starting point of the continuous data.
• To
Specify the destination value at the ending point of the continuous data.
• Curve
Specifies the kind of the change in data.
• Interval Time
Specify the spacing (in ticks) between events of the continuous data.
● For details on all of the parameters and values of the Create Continuous Data command, refer to “CREATE
CONTINUOUS DATA popup” (Screen Guide; p. 67).
Entering data with a smooth succession of values (Create Continuous Data)
MV-8800_e.book 198 ページ ２００６年１１月１０日 金曜日 午後１時４８分