M-95
MV-8800 Owner’s Manual
5
Creating a patch
Chapter 5
Creating a patch
Making a patch settings
1.
Press [INSTRUMENTS].
The INSTRUMENTS screen (Screen Guide; p. 114) will appear.
2.
Use CURSOR [ ] [ ] to select the part that uses the patch you want to edit.
The selected part number (the current part) will be highlighted.
3.
Press [F5](Patch Edit).
The PATCH EDIT screen (Screen Guide; p. 118) will appear.
Part number/Patch name
Selects the part that use the patch you want to edit.
Patch Coarse Tune
Adjust the pitch of the entire patch in steps of one semitone.
Patch Fine Tune
Adjust the pitch of entire patch in steps of one cent.
Analog Feel Depth
Applies irregularity to the patch, simulating the natural instability that is typical of an analog synthesizer.
Pitch Bend Range Down
Specifies the amount by which the pitch of the patch will change (in semitones) when you operate the pitch
bender downward.
●
For details on the parameters, refer to “PATCH EDIT screen” (Screen Guide; p. 118).
●
Strike the pads to hear the result of your settings. To check the pads to which the sounds are assigned, press
[PAD BANKS] to display the “PAD BANKS popup” (p. 5).
●
One cent = 1/100th of a semitone
1
2
2
3
4
5
MV-8800_e.book 95 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
