Roland MV-8800

List of available editing commands
M-197
MV-8800 Owner’s Manual
Editing a song / pattern
10
This lets you extract only specific note events from a track, and move them to a specified other track.
For example, if you have an entire drum performance recorded in a single track, you can use this command
to extract just the sname drum notes and place them on a different track.
❍ Parameters to specify
• Note Range
Specifies the range of note numbers that will be extracted.
• Type
Specifies what will happen after the note events are extracted from the original track.
• Send To
Specifies how the extracted note events will be recorded.
• Track
Specifies the track number in which the extracted note events will be places. This parameter is available in
case of the Send To is “One Track.”
● For details on all of the parameters and values of the Split Notes command, refer to “SPLIT NOTES popup”
(Screen Guide; p. 66).
● You cannot extract data from audio tracks or pattern tracks.
● If you set the larger value at the left-hand cursor than the value at the right-hand cursor, the SPLIT NOTES
operation will be executed for the note nnumber other than you set at the Note Range parameter.
● If you use the Send To “One Track” setting to place the extracted data in a track that already contains data, the
extracted data will be combined with the existing data in the destination track.
● If you want to separate drum notes into individual tracks, use the Send To “Separate Tracks by Pitch” setting.
Extracting specific note events (Split Notes)
MV-8800_e.book 197 ページ ２００６年１１月１０日 金曜日 午後１時４８分