Roland MV-8800

Using the locator
M-141
MV-8800 Owner’s Manual
Using the sequencer
8
You can edit the location of a locate point you stored.
1.
Press [SONG].
The SONG screen (Screen Guide; p. 8) will appear.
2.
Press [LOCATOR].
The LOCATOR popup (Screen Guide; p. 59) will appear.
3.
Move the cursor to the locate number (0–9) that you want to edit.
4. Press [F3](Edit).
The EDIT LOCATOR popup will appear.
5.
Move the cursor to the measure, beat, and tick, and edit the location as desired.
6.
Press [F1](Set).
The locate point will be assigned to the new time you specified.
1.
Press [LOCATOR].
The LOCATOR popup (Screen Guide; p. 59) will appear.
2. Move the cursor to the locate number (0–9) that you want to edit the name.
3.
Press [F4](Name).
The EDIT LOCATOR NAME popup (Screen Guide; p. 3) will appear.
4.
Move the cursor to a character and use the VALUE dial or the numeric keys to input the
desired character.
5.
When you’ve finished entering the name, press [F5](OK).
1.
Press [LOCATOR].
The LOCATOR popup (Screen Guide; p. 59) will appear.
2.
Move the cursor to the locate number (0–9) that you want to delete.
3.
Press [F2](Clear).
The locate point will be deleted.
Editing a locate point
Naming a locate point
Deleting a locate point
MV-8800_e.book 141 ページ ２００６年１１月１０日 金曜日 午後１時４８分