Roland MV-8800

Other functions
M-317
MV-8800 Owner’s Manual
21
Chapter 21
Other functions
Settings for the entire MV-8800
Here’s how to make settings that affect the overall operation of the MV-8800.
1. Press [SYSTEM].
The SYSTEM MENU screen (Screen Guide; p. 172) will appear.
2.
With the cursor located in the upper row of icons, press [F1](Global). Alternatively, select
the GLOBAL icon and press [ENTER].
The GLOBAL screen (Screen Guide; p. 173) will appear.
• Input Select
Specifies the connector that will be used for input to the MV-8800.
• Sampler Output Gain
Adjusts the level (volume) at which the sample will play. The audio output from the sampler may be distorted
if this parameter is set to a high value.
• Digital Output Select
Selects the audio signal that will be output from the OUTPUT DIGITAL A and B connector.
• Digital Out Copy Protect
If this is turned On, copy protection data will be added to the signal that is output from the OUTPUT DIGITAL
A,B connectors.
• Master Tune
Adjusts the overall tuning of the MV-8800. The displayed value is the frequency of the A4 key (middle A).
• Preview Length
Specifies the duration of playback when you press PREVIEW [TO ( )] [FROM ( )].
• HD Format Protect
If this is On, it will not be possible to format the hard disk.
• Power Up Mode
Selects the mode in which the sequencer will be at power-up.
● For details on all parameters, refer to “GLOBAL screen” (Screen Guide; p. 173).
MV-8800_e.book 317 ページ ２００６年１１月１０日 金曜日 午後１時４８分