Roland MV-8800

M-65
MV-8800 Owner’s Manual
2
Importing data
Importing the WAV or AIFF files
You can import a WAV file or AIFF file and use it as sample data for the MV-8800.
1.
Press [IMPORT].
The IMPORT screen (Screen Guide; p. 219) will appear.
2.
Press [F1](Select Drive).
The SELECT DRIVE popup will appear.
3.
Use CURSOR [ ] [ ] to select the disk containing the WAV/AIFF file you want to import,
and press [F5](Select).
The contents of the disk will be displayed.
4.
Use CURSOR [ ] [ ] [ ] [ ] to select the WAV/AIFF file you want to import.
Press CURSOR [ ] to show the contents of the folder. To return to the “parent folder” in which you were
previously, press CURSOR [ ].
• F-buttons
5. Press [F5](Import).
The data will be imported, and the RESULT popup will appear.Here you can audition the imported data. A
sample number will be assigned to the imported data.
fig.sample-result-screen
6.
Specify the parameters.
• Start Point / End Point
Specify the points at which the sample will start playing and stop playing. The Start Point - End Point region
is highlighted.
Range: 000000000.000–The end of sample
• BPM Base Note
Draws measure and beat lines on the displayed sample.
Range: , , (initial value), , / x 1–x 4–x 65535
● Some AIFF files are recorded in the AIFF-C (AIFC) format. The MV-8800 cannot import AIFF files recorded in
this format.
F-button
Explanation
[F1](Select Drive)
Displays the SELECT DRIVE popup, letting you switch the drive form which to select files.
[F2](View) Here you can limit the type of the file that will appear in the IMPORT screen.
[F3](Mark On/Off) Turns the check mark on/off for a file.
[F4](Preview) Auditions the currently-highlighted file. To hear auditioning, press [F4](Preview).
[F5](Import) Imports the selected or check marked file(s).
● By using [F3](Mark On/Off) to assign a mark to files you want to import, you can import multiple files in a single
operation.
● By pressing [MENU] and selecting “All Mark” you can select or de-select all files on the list.
● The sample number is shown above the waveform display.
● The BPM is displayed below the BPM Base Note. The displayed BPM value is calculated from the BPM Base
Note setting and the playback length of the sample.
MV-8800_e.book 65 ページ ２００６年１１月１０日 金曜日 午後１時４８分